Open Metal Bezel Frames for Resin — Novelty Shapes | Gold & Silver

Available Styles

Silver Whales — 29×38mm
Open whale body outline with a spouting water detail at the top. Silver-tone finish. Pack of 3.

Silver Umbrellas — 43×32mm
Open umbrella outline with a decorative wavy hem and curved handle. Silver-tone finish. Pack of 3.

Silver Leaves — 35×23mm
Open maple leaf outline with a serrated edge profile. Silver-tone finish. Pack of 3.

Silver Mushrooms — 34×30mm
Open mushroom cap outline with a solid textured stem. Silver-tone finish. Pack of 3.

Silver Saturns — 33×57mm
Open planet-and-ring (Saturn) outline. Silver-tone finish. Pack of 3.

3 Silver Shamrocks — 44×35mm
Open 4-petal flower/shamrock outline. Silver-tone finish. Pack of 3.

4 Silver Flower Connectors — 29×23mm
Open 4-petal cherry blossom outline. Silver-tone finish. Pack of 4.

3 Gold Shamrocks
Open 4-petal flower/shamrock outline. Gold-tone finish. Pack of 3.

Gold Fans — 42×30mm
Open folding fan frame — round open area with a decorative ribbed fan at the base. Gold-tone finish. Pack of 3.

Gold Mushrooms — 34×30mm
Open mushroom cap outline with a solid textured stem. Gold-tone finish. Pack of 3.

Details

Material: zinc alloy
Finishes: silver-tone or gold-tone plating depending on style
Open-back design — fill freely with UV or epoxy resin and inclusions
Pre-formed hang loop on each frame — no drilling required
Compatible with UV resin and two-part epoxy resin

How to Use

Tape the back of the frame with resin tape or set it face-down on a silicone mat. Fill the open area with resin, add glitter, dried flowers, or crystal chips, then cure. Once set, remove the tape and attach a jump ring through the hang loop to connect to a chain, earring wire, or keychain clip.

Frequently Asked Questions

Will resin stick to the metal frame?
Yes — resin bonds well to zinc alloy. No primer or prep is needed. The open-back design means resin fills the cavity and cures flush with or slightly proud of the frame edge, creating a secure bond.

How do I stop resin from leaking out the back?
Place the bezel face-up on a silicone mat (resin won’t stick to silicone) or seal the back with resin tape before filling. Fill slowly in thin layers to avoid overflow.

Can I add inclusions like dried flowers or glitter?
Yes — these bezels are ideal for encasing dried flowers, glitter, crystal chips, foil flakes, and other small inclusions. Fill with a base layer of resin, add inclusions, then seal with a top layer and cure.

Do I need to sand or finish the back after curing?
If resin overflows slightly onto the back, it can be sanded smooth once fully cured using fine-grit wet/dry sandpaper. For a gloss finish, apply a thin seal coat of UV resin and cure.

What jump ring size fits the hang loop?
Most frames work well with a 4–6mm jump ring. The exact fit will depend on the style — we recommend using round-nose pliers to open and close jump rings securely.